Question: Removing Metal Fence Posts Set In Concrete?

How do you remove a metal fence post from concrete?

To remove a metal fence post set in concrete, you can pry it out with a car jack, tractor, or lever made from lumber. If it’s set in continuous concrete, you may need some heavier machinery, like a jackhammer.

Will fence posts rot in concrete?

A: Actually, your point is well taken. Simply setting the posts in concrete does create a condition that will accelerate rot in the bottom of the posts. With pressure-treated posts, the rot will be slow. The concrete at the top should be sloped away from the post to grade level to avoid water pooling around the base.

What is a post puller?

An electric vehicle having a powered drum for handling wire rope used to pull mine props after coal has been removed; used for the recovery of the timber.

How do you straighten a concrete fence post without removing it?

The Fix-A-Fence Solution

  1. Step 1 – Prepare the Site.
  2. Step 2 – Prepare the Fix-a-Fence Kit.
  3. Step 3 – Position the Bracket in the Hole.
  4. Step 4 – Mix a 60lb Bag of Concrete.
  5. Step 5 – Fill the Hole with Concrete.
  6. Step 6 – Take a Break While the Concrete Cures.
  7. Step 7 – Reposition the Fence Post and Attach the Bracket.
You might be interested:  Readers ask: How To Lay Concrete Block Wall?

How do you remove an aluminum fence post?

In that, Yes, the post can be removed by digging it out and pulling it upwards Before you pull upwards make sure the screws going into the ends of the sections are removed on both sides of the post. Then as you pull the post up the sections will go with it until they break free

How do you cut metal fence posts?

  1. Measure and mark the fence post at the desired length.
  2. Clamp the post in a heavy-duty vise with the mark about 4 to 6 inches from the end of the vise.
  3. Cut the fence post with a hack saw or reciprocating saw.
  4. Smooth the jagged metal edge where the post was cut with a file or power grinder.

Is 2 feet deep enough for fence posts?

Project Instructions



The depth of the hole should be 1/3-1/2 the post height above ground (i.e., a 6-foot tall fence would require a hole depth of at least 2 feet).

How long will a pressure treated post last in the ground?

3) A deck built with pressure treated wood will last a long time. Promotional literature promises lifelong performance for pressure treated wood. The Forest Products Laboratory and other research groups have shown that treated wood stakes placed in the ground for more than 40 years remain rot-free.

Should you use concrete for fence posts?

Concrete is the most secure material for setting fence posts, especially if you have sandy soil. Using premixed concrete rather than dry concrete will ensure ultimate security. While concrete is sturdy, it lacks the drainage of gravel and can trap moisture, ultimately leading to rot.

Leave a Reply

Your email address will not be published. Required fields are marked *