Question: How To Install A Railing On A Concrete Porch?

How do you attach a railing to a concrete porch?

It’s an easy project that you should be able to finish in less than a day.

  1. Measure on the concrete where each post will be placed.
  2. Place the bolt-down post holders on the concrete.
  3. Mark each hole on the post holder.
  4. Make the holes in the concrete with a hammer drill and bit.
  5. Secure each post holder with a socket wrench.

How do you attach something to concrete without drilling?

A simple fix might include an adhesive or adhesive-baked hook, while there are other fasteners like hard wall hooks and masonry nails. Powder-actuated fasteners and concrete nail guns are useful for supporting frames and providing a much greater hold.

Why deck posts should not be set in concrete?

A deck post should always be placed on top of footing, not inside concrete because it can break. Concrete tends to absorb moisture and wood expands when it gets wet, so these two factors combined will result in the wood breaking the concrete.

How do you attach something to concrete?

Simply drill a hole into the concrete, hold the fixture you’re fastening over the hole, then use a hammer to tap the anchor into the hole. As you drive in the pin, the sleeve expands outward, trapping the anchor in the hole.

You might be interested:  Quick Answer: How Much Does Concrete Pumping Cost?

How much does it cost to install vinyl porch railing?

Average Cost of Vinyl Porch Railing



You can install 10 feet of vinyl railing for around $450, or $20-$40 per foot. Labor will cost around $150 for three hours ($50 per hour) and materials will be roughly $300.

Can Trex go over concrete?

Some may be wondering, “Can you lay Trex composite decking over concrete?” Yes!

Do you put concrete inside vinyl fence post?

All end and gate posts must be filled with concrete and 2 pieces of 1/2″ rebar for maximum strength and performance. The Rebar Separator Clip will assure that the rebar inside the post is positioned in opposing corners of the post and is held in a vertical position.

How do you install newel post on concrete?

Remove the nut from the bolt and place the newel post onto the bolt, aligning the center mark on the bottom of the post with the anchor bolt. Thread the post onto the coarse threads of the anchor bolt. Tighten the posts onto the bolt and tight against the concrete floor.

Leave a Reply

Your email address will not be published. Required fields are marked *