Replacing Shower Drain In Concrete Floor?

How much does it cost to replace a shower drain?

Install a Shower Drain national average cost



The national average materials cost to install a shower drain is $56.20 per drain, with a range between $50.42 to $61.98. The total price for labor and materials per drain is $304.76, coming in between $276.31 to $333.21.

Do I need a shower pan on concrete floor?

You will have to ensure that there is no wax, oil, grease, or soap scum on the face of the concrete slab that could ruin or reduce the bond. After that, I recommend that you install a sloped shower pan to contain the shower water and prevent harmful organisms from becoming resident in the surrounding walls and floor.

Can I use a basement floor drain for a shower?

A basement drain is often a “French” or “princess” drain, designed for intermittent use. They aren’t designed for a constant, moderate flow of water, and will back up. If the drain is traditional and tied to existing sewer, yes it can be used as a shower drain.

You might be interested:  Readers ask: How To Remove Indoor Outdoor Carpet Glue From Concrete?

How do you install a basement shower without breaking concrete?

The best way to install a basement bathroom shower without damaging your floors is to look into an upflush toilet system. While traditional basement showers require you to drill into concrete to add a drain, a Saniflo system sits on top concrete floors.

Can I pour concrete over PVC pipe?

Pour the mixed concrete around the PVC pipe, using a large, metal funnel or a spade. Pack the concrete around the PVC pipe to prevent air gaps. Pack the layer directly underneath the PVC pipe; it should be packed tight to create a solid, firm foundation and to prevent cracking during temperature fluctuations.

How do I fill a hole in my concrete basement floor?

  1. Use a hammer and a cold chisel to level the bottom of the hole and undercut its sides slightly so the patch can’t pop loose.
  2. Brush on a concrete bonding liquid,
  3. Mix the concrete with water and scoop some into the hole.
  4. To burnish the surface very smooth, use a steel trowel (shown) on the final few passes.

Do I need a trap in a shower drain?

Yes, shower and tub drains require a trap in the plumbing to prevent harmful sewer gases from coming into the home.

How much does it cost to replace a sewer line under a concrete slab?

The cost to replace a sewer line under a slab costs $3,000 to $5,000 for smaller jobs and $15,000 to $20,000 total for larger jobs. Trenching under a slab can cost an extra $150 to $200 per foot.

How much does it cost to replace drain stack in basement?

Cost to Replace Drain Pipe in Basement



The price to replace a basement drain averages $1,650. This includes removal and replacement. The total increases if the plumber must cut into the concrete slab, which is common for floor drain installation.

You might be interested:  Readers ask: How To Seal Cracks In Concrete Walls?

Can you put tile directly on concrete?

A: It’s perfectly acceptable to put tile directly on concrete — with a couple of caveats. First, it is important to determine if there is moisture coming up from the slab. Those products should help prevent any cracks in the slab from damaging the newly installed tile.

How thick should a concrete shower pan be?

As a general rule, a shower curb foundation is 3 to 4 inches thick and 4 to 6 inches tall, with finish material adding to these dimensions.

Is wire mesh necessary in shower pan?

Before installing the final layer of mortar on the shower pan you will need to install expanded wire mesh on the shower curb, over the PVC pan liner. The wire mesh will cover the entire curb from the inside of the shower pan at the top of the mortar floor over the top of the curb and down to the bathroom floor.

Leave a Reply

Your email address will not be published. Required fields are marked *