Readers ask: How Much Does 80 Lbs Of Concrete Cover?

How many square feet does 80 lbs of concrete cover?

4 sq feet in that amount of cement.

How many cubic feet are in a 80 pound bag of concrete?

6 cubic feet for an 80 lb bag.

How many 80 lb bags of concrete do I need?

Use the following yields per each bag size: 40 pound bag yields.011 cubic yards. 60 pound bag yields.017 cubic yards. 80 pound bag yields.022 cubic yards.

How much quikrete do I need for a 10×10 slab?

For a 10 x 10 slab, you would need 77 60-pound bags or 60 80-pound bags. If we add an extra 10%, that’s an extra 8 60-pound bags or 6 80-pound bags. Whatever the size of your project, use the formula above to calculate how much concrete you’ll need!

Can you pour concrete directly on dirt?

Long story short, yes you can pour concrete over dirt.

You might be interested:  Often asked: How To Repair Cracks In Concrete Slab?

How many bags of cement do I need for 100 square feet?

Ans.:- 7.6 no of cement bags (381.30 kgs) are required for 100 sq ft rcc roof slab 4 inch thick m20 grade concrete. Ans.:- 7.6 bags (381.30 kgs), 9.5 bags (476.10 kgs) & 11.4 bags ( 570.8 kgs) cement are required for 100 sq ft rcc roof slab 4 inch, 5inch & 6 inch thick respectively in m20 grade of concrete.

How many bags of concrete do I need for a post hole?

Mix two 50lb bags of concrete with water in a mixing tub or 5-gallon bucket. Add concrete into the hole and around the 4” x 4”. Depending on your climate, let concrete set up for 24 – 48 hours.

How many cubic feet is a 60 lb bag of concrete?

30 cubic feet, 60 pounds of concrete mix yields. 45 cubic feet and an 80-pound bag yields.

How many bags of cement do I need for 1 yard?

# It takes approximately 5 Bags of Portland cement, 8 cubic ft of sand, and 20 cubic ft of gravel to make approximately 1 cubic yard (27 cubic feet) of concrete.

How much does a bag of concrete make?

one 20kg bag will cover an area of 1.1m2 to a depth of approximately 10mm. or 108 x 20kg bags equates to one cubic metre of mixed concrete.

How thick should a concrete driveway be?

As for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.

You might be interested:  Quick Answer: Best Steel Toe Work Boots For Standing On Concrete All Day?

How many square feet will one bag of quikrete cover?

15 cubic feet for every 20 pounds of mix, so a 40-pound bag yields. 30 cubic feet, 60 pounds of concrete mix yields.

What is cheaper poured concrete or pavers?

As far as installation costs and concrete costs go, poured concrete is technically the most affordable per square foot. However, even though the upfront cost of pavers is higher, concrete pavers offer greater value and durability than poured concrete and stamped concrete.

Leave a Reply

Your email address will not be published. Required fields are marked *