Readers ask: How Many Square Feet Does 1 Yard Of Concrete Cover?

How much concrete do I need for a 10×10 slab?

For a 10 x 10 slab, we’d suggest a mix with a capacity of about 4,000 pounds per square inch, or psi. This is basic for residential projects, and it can withstand traffic and support heavy loads.

How much concrete do I need for a 40×60 slab?

On average, the amount of concrete you will need for a 40×60 slab for a barndominium will be $9,500 to $14,400. This calculation takes into factor the area of the slab, the cost of the concrete mix, and the national average of labor and materials you will need for the job.

What is the cost of 1 yard of concrete?

How much is a yard of concrete? When estimating the cost of concrete, use $125 per yard as a ballpark figure. However, concrete prices differ by region, and you’ll have to pay a ready mix delivery fee, plus factor in labor charges if hiring a contractor.

You might be interested:  FAQ: Where To Watch Dragged Across Concrete?

How much does it cost to pour a 30×50 slab?

Concrete Slab Cost Calculator

Size (in feet) Approximate Cost
30×40 $7,200
30×50 $9,000
40×40 $9,600
40×60 $14,400

How many square feet does an 80lb bag of concrete cover?

4 sq feet in that amount of cement.

How many 80lb bags of concrete makes a yard?

If you’re using 80lb bags of concrete, you’ll need 45 bags to make a yard.

How much would a 30 by 40 garage cost?

An average 30×40, 1,200 sq ft, metal garage costs between $22,800 and $30,000, or $19-$25 per square foot.

How much does a 20×20 concrete patio cost?

Cost to Install Concrete Patio by Size

Size in Feet Square Footage Price Range
12×14 168 $1,400 – $4,000
15×15 225 $1,800 – $5,500
16×18 288 $2,300 – $7,200
20×20 400 $3,000 – $10,000

What is the difference between a concrete slab and a cement slab?

What is the difference between cement and concrete? Although the terms cement and concrete often are used interchangeably, cement is actually an ingredient of concrete. Concrete is a mixture of aggregates and paste. The aggregates are sand and gravel or crushed stone; the paste is water and portland cement.

Can I pour a 2 inch concrete slab?

If done properly, new concrete can often be poured right over an existing slab. For this to be feasible, the contractor needs to pour at least 2 inches thick, use smaller aggregate, and incorporate reinforcement such as welded wire mesh or fiber mixed into the concrete.

Is mixing your own concrete cheaper?

One of the least expensive ways to get concrete is to mix your own. You can buy bags of the mix from a home improvement store. Typically, you only have to add water for it to be ready to pour. Otherwise, you risk getting a weaker concrete once it cures, which could lead to cracks or crumbles within a couple of years.

You might be interested:  Quick Answer: How To Install Carpet On Concrete Basement Floor?

How many bags of concrete makes a yard?

On average, it will take 90 40lb bags, 60 60lb bags, or 45 80lb bags to fill one cubic yard of concrete.

Can you pour concrete directly on dirt?

Long story short, yes you can pour concrete over dirt.

Should you put plastic under concrete?

Recently, though, research has shown that the old traditional layer of 6-mil Visqueen (polyethylene plastic) under the slab is seldom effective for two main reasons: Although it may seem water-tight, this grade of material allows a lot of water vapor to pass through.

How much would a 40×60 concrete slab cost?

How much does a 40×60 concrete slab cost? It would be about $8,500 to $12,000 for a 40×60 foot concrete slab, 6 inches thick. That’s based on national averages of around $5 per square foot for a fully engineered, finished concrete slab, including labor and materials.

Leave a Reply

Your email address will not be published. Required fields are marked *