Quick Answer: How To Remove Concrete Fence Post Base?

How do you remove concrete post footings?

Steps in Removing Concrete Deck Footings

1. Ensure that the structure is supported, remove the footing post if applicable.
2. Using a spade shovel manually excavate around the footing at least 3/4 the way around and at least 2/3rds of the length of the footing.
3. Dig until you see the footing wiggle a bit.

How do you break a concrete fence post base?

Break the concrete footing into two or more sections, using a cold chisel and steel mallet. Drive the tip of the chisel into the seam between the base of the post and top of the concrete until the concrete breaks. Repeat this on the opposite side of the post.

Are concrete fence posts easy to remove?

Thinking a bit more about it, the easiest way to get mine out whole might have been to dig a hole/slot beside the post, tilt it into the hole then pivot/pull it up out of the ground over a log/fulcrum/roller at the end of the slot using the weight of the long post to counterbalance the concrete slug on the end.

Can you reuse fence posts with concrete?

ARB1977. If the poles are out of the ground, hit the concrete with a sledge hammer a couple times and it comes right off. Some of those older poles are nice and heavy gauge (not like the thin ones sold now) and if not totally rusted are perfect to reuse.

How do you straighten a concrete fence post without removing it?

The Fix-A-Fence Solution

1. Step 1 – Prepare the Site.
2. Step 2 – Prepare the Fix-a-Fence Kit.
3. Step 3 – Position the Bracket in the Hole.
4. Step 4 – Mix a 60lb Bag of Concrete.
5. Step 5 – Fill the Hole with Concrete.
6. Step 6 – Take a Break While the Concrete Cures.
7. Step 7 – Reposition the Fence Post and Attach the Bracket.

Can a rotary hammer break concrete?

Rotary hammers use an electro-pneumatic hammer piston to generate high impact energy, which allows it to drill or demolish concrete.

How do you break down buried concrete?

When thinking about breaking up concrete, most of our minds jump straight to jackhammer. But you can probably do the work with a metal sledgehammer and a little elbow grease. Sledgehammer is the best tool to use if the slab of concrete is three inches thick or less. Dig at the base of the slab to find the bottom.

How do you replace a concrete fence post?

Dig a hole around 1 side of the fence post.



With a shovel, break into the ground surrounding the fence post’s concrete base. Keep digging until you create a half-circle gap between the ground and concrete. If possible, dig a hole that is as deep as the concrete itself, giving the post as much wiggle room as possible.

Should I replace fence posts?

Depending on how badly they are damaged, some fence posts will pull right out of the ground. If the wood crumbles in your hands or the rot or termite damage covers more than about 30% of the post, you will need to replace the entire post.

Can you reuse old fence post holes?

Here is what I have done in that situation. Take a sledge, break the old concrete off the old post, save it, if the post is still good enough to reuse, great, use it. Also have a supply of more rubble ( broken concrete, stones, broken bricks, etc.)

Can you reuse metal fence posts?

Whether the fence is over your property line, or maybe the fence was installed badly, you can actually pull chain link fence posts and reuse them. Though it isn’t technically challenging to dig out a fence post, it can be hard work, especially if your posts are set in concrete.