Quick Answer: How To Move A Shower Drain In A Concrete Floor Video?

How do I move a shower drain to a concrete slab?

How to Move a Shower Drain in a Concrete Floor

  1. Step 1: Mark Cuts With Red Crayon.
  2. Step 2: Take Safety Precautions.
  3. Step 1: Cut With an Angle Grinder.
  4. Step 2: Break Concrete Into Smaller Pieces.
  5. Step 1: Dig Trench for New Pipe.
  6. Step 2: Purchase Correct Size Drain Line.
  7. Step 3: Cut Old Drain Line.
  8. Step 4: Reattach Old Drain Line Piece.

Can you move plumbing on a concrete slab?

Moving the Water Lines



The average cost for moving the plumbing in a 200 square foot kitchen with a slab floor is $2,000 to $7,000. And the cost for the pipes themselves ranges from $10 to $50 per linear foot. And this does not include any concrete work that it would take to get to the pipes.

How do you install a floor drain in a concrete slab?

How to Install a Floor Drain in a Concrete Slab

  1. Prepare Your Space. While it’s easiest to install a floor drain prior to pouring your cement, you can do it after the floor has been set.
  2. Plan Drainage. New floors are easier to plan, as you can lay out the pipes in place and then install the floor over top.
  3. Dig Trenches.
  4. Pour New Concrete.
  5. Add a Drain Cover.
You might be interested:  Which Child Has Probably Entered The Stage Of Concrete Operations?

Does the shower drain have to be centered?

The shower drain has to be at the lowest point of the shower floor, and so the floor has to slope down toward the drain from all directions. For showers that have a bench built in, placing the drain under the bench will keep it out of the way.

Can I use a basement floor drain for a shower?

A basement drain is often a “French” or “princess” drain, designed for intermittent use. They aren’t designed for a constant, moderate flow of water, and will back up. If the drain is traditional and tied to existing sewer, yes it can be used as a shower drain.

How is plumbing run on a slab?

There is no crawlspace or basement beneath, which means the plumbing is under the slab foundation. Concrete slab foundations that encase the home’s plumbing lines, also called under slab plumbing, could have pipes made of copper, cast iron, or galvanized steel and these materials are prone to decay over time.

Can you run water pipes in a concrete floor?

During the initial building of a home that has a concrete slab foundation and basement level, any plumbing that runs under the home must be put in before the concrete is poured, since the plumbing runs in the dirt, not within the actual concrete.

Can you install a toilet on a concrete floor?

You can install a toilet on a concrete floor. It may seem intimidating, but installing a new toilet can be a DIY project that you can be proud of.

How high do you set the shower drain?

The top of the Pipe should be no higher than, and no more than 1/8″ lower than, the top surface of the floor on which the base will be set. Hand-tighten Drain Nut, and then tighten the rest of the way (about 1/2 turn) with a wrench.

You might be interested:  What Does Mold Look Like On Concrete?

How much does it cost to move a shower drain?

If you’re relocating the shower, expect to pay an extra $900 – $1,200 (same as the toilet). There are specific codes that plumbers must follow to make sure drains and vents are correctly angled and securely fitted.

Can you tie a shower drain into a toilet drain?

You cannot connect a shower to the toilet drain or what would be the waste arm. It needs to be piped within a properly vented branch, unless you revent the new shower line which I be leave you are under the IPC code would need to be wet vented.

Can I put a drain in my garage floor?

Can you put a floor drain in an existing garage? Yes, even if the floor is just a concrete slab. The drain can be attached to an existing sewer line or just flow to a runoff outside. If water is pooling in your garage, a floor drain can help you remove the mess before it spreads into your house.

Does a garage floor drain need a trap?

Re: Floor Drains do they require trap venting? If the drain is just going to terminate outside, you might consider a trap just to stop air from blowing in and out of your building through the drains. Not an issue into a closed dry well, but might be if just flowing into a pit.

Leave a Reply

Your email address will not be published. Required fields are marked *