Contents
- 1 Can you install a toilet on a concrete floor?
- 2 Can you move plumbing on a concrete slab?
- 3 Should you caulk around a toilet?
- 4 How do you replace a toilet flange on a concrete floor?
- 5 How do you remove a toilet from a concrete floor?
- 6 Should a toilet flange be flush with the floor?
- 7 Does toilet flange need to be screwed to floor?
- 8 Do you put the wax ring on the toilet or the flange?
- 9 Can you run water pipes in a concrete floor?
- 10 Is it hard to move toilet plumbing?
Can you install a toilet on a concrete floor?
You can install a toilet on a concrete floor. It may seem intimidating, but installing a new toilet can be a DIY project that you can be proud of.
Can you move plumbing on a concrete slab?
Moving the Water Lines
The average cost for moving the plumbing in a 200 square foot kitchen with a slab floor is $2,000 to $7,000. And the cost for the pipes themselves ranges from $10 to $50 per linear foot. And this does not include any concrete work that it would take to get to the pipes.
Should you caulk around a toilet?
Caulk helps to keep the toilet secured to the floor. The bolts are really supposed to keep the toilet secure, but caulk helps. Some people prefer to caulk all around the toilet and leave about a one-inch gap in the caulk at the back of the toilet to allow water to escape out in the event of a leak.
How do you replace a toilet flange on a concrete floor?
Instructions
- Cut off the Old Flange and Obstructions. After you remove the toilet, you will probably find an existing toilet flange.
- Scrape Off the Old Wax Ring.
- Place T-Bolts in the New Toilet Flange.
- Position the Toilet Flange.
- Drill Holes Into the Concrete.
- Screw the Toilet Flange Onto the Concrete.
How do you remove a toilet from a concrete floor?
Use a small hammer and chisel to carefully crack the back of the pan near the joint to the waste pipe. This will separate the pan spigot from the rest of the pan. Then smash the pan away from the pipe with a bigger hammer and clean off any cement on the floor.
Should a toilet flange be flush with the floor?
The toilet flange needs to be on top of the finished floor. Meaning the bottom edge of the flange needs to be on the same plane as the toilet. So if your toilet sits on the tile, the flange needs to be on top of the tile too. The spacing of the toilet exit “horn” and sealing surface is designed for this height.
Does toilet flange need to be screwed to floor?
The flange should be fastened to the floor. Dry fit the toilet to make sure it doesn’t rock. If it does rock, use shims to prevent rocking – just tightening the bolts probably will not stop the rocking but will risk cracking the toilet or breaking the flange. We would usually screw it down during the rough in.
Do you put the wax ring on the toilet or the flange?
Place the wax ring on the closet flange, not on the toilet. Then, pick up the toilet and set it evenly over the closet flange, making sure the bolts come through the bolt holes in the toilet base. Fine-tune the toilet position, so it’s right where you want it, then push it straight down so it smashes the wax evenly.
Can you run water pipes in a concrete floor?
During the initial building of a home that has a concrete slab foundation and basement level, any plumbing that runs under the home must be put in before the concrete is poured, since the plumbing runs in the dirt, not within the actual concrete.
Is it hard to move toilet plumbing?
Moving a toilet is not so much about moving the actual fixture—in fact, installing a toilet is a simple job that takes less than an hour—as it is about moving the drainage and the water supply plumbing to the new location. Once all of the plumbing is in place, installing the toilet is a relatively easy task.