Contents
- 1 How thick does a concrete floor need to be?
- 2 Can you pour concrete directly on the ground?
- 3 Do you need rebar for 4 inch slab?
- 4 Do you need to insulate a concrete floor?
- 5 Should you put plastic under concrete?
- 6 How many bags of concrete do I need for a 10×20 slab?
- 7 Do you need a membrane under concrete?
- 8 Is sand a good base for concrete?
- 9 What is the best base for a concrete slab?
- 10 Do you need crushed rock under concrete?
- 11 Do you need rebar for 6 inch slab?
- 12 Do you need wire mesh for 4 inch slab?
- 13 Is wire mesh better than rebar?
How thick does a concrete floor need to be?
Standard concrete floor slab thickness in residential construction is 4 inches. Five to six inches is recommended if the concrete will receive occasional heavy loads, such as motor homes or garbage trucks.
Can you pour concrete directly on the ground?
Long story short, yes you can pour concrete over dirt.
Do you need rebar for 4 inch slab?
No, you do not need rebar for a 4–inch slab of concrete on grade. A 4–inch-thick slab cast on the ground and in permanent contact with it will float and rebar is not required. Rebar is recommended on concrete measuring 5 – 6 inches thick.
Do you need to insulate a concrete floor?
Insulating a concrete floor. When building or renovating a new space, insulation should always be considered. From preventing damp to reducing heat loss and aiding with noise dampening, below-grade insulation is always important.
Should you put plastic under concrete?
Recently, though, research has shown that the old traditional layer of 6-mil Visqueen (polyethylene plastic) under the slab is seldom effective for two main reasons: Although it may seem water-tight, this grade of material allows a lot of water vapor to pass through.
How many bags of concrete do I need for a 10×20 slab?
A 60-pound bag yields. 017 cubic yards, and an 80-pound bag yields. 022 cubic yards. For a 10 x 10 slab, you would need 77 60-pound bags or 60 80-pound bags.
Do you need a membrane under concrete?
These days, damp proof membranes are required in the construction of all new buildings to prevent rising damp. These strong and highly durable Polyethylene 1200 Gauge DPMs are sandwiched between the hard core and concrete slab to form an impermeable layer.
Is sand a good base for concrete?
Pour concrete over a solid, well-drained base
of sand or gravel over clay and other poorly draining soils to provide even support.
What is the best base for a concrete slab?
Most concrete contractors want a mix of coarse and fine aggregate to create a compactable base that is going to be safe for settlement and drainage. Crusher run (a mix of crushed stone and stone dust) is one of the best base materials for concrete flatwork.
Do you need crushed rock under concrete?
Because concrete is a very porous material, it will absorb any moisture that it contacts. This can cause pooling. Without crushed stone, pooling water will settle under it and erode your slab. Adding a layer of crushed stone will add proper drainage, as well as create a barrier between your slab and the ground.
Do you need rebar for 6 inch slab?
Rebar is recommended for concrete that measures 5-6 inches in depth. The type of and intended use of concrete impacts the need for rebar reinforcement. Rebar must be placed at the center of or slightly above the center of the concrete slab—hence why it should be a certain thickness for best results.
Do you need wire mesh for 4 inch slab?
Do you need wire mesh for 4 inch slab? No, they do not. Larger projects or slabs may need steel reinforcement to provide support or extra strength. Wired mesh can also help resist cracking.
Is wire mesh better than rebar?
In summary, rebar vs wire mesh can have costly differences. Rebar remains stronger and ensures consistent contact in the soil where as wire mesh is unpredictable and often results in a week concrete foundation.