Question: How To Install Aluminum Threshold On Concrete?

How do you install a threshold on a concrete floor?

Installing a door threshold on concrete slab

  1. Lay down a bead of caulk (I have the DAP Alex Plus) at the very edge of the slab to prevent water from running under the threshold,
  2. Add more caulk to the rest of the underside of the threshold and put in in place on the slab,
  3. Fasten the threshold to the concrete with screws?

How do you glue threshold to concrete?

PL Premium polyurethyne construction adhesive is the best glue on the face of the earth, IMO and will practically weld your wood threshold to the concrete. Squeeze a bead or three under where the thresh will go and smack it down into the glue. Weight it in place overnite and you be fine.

How do you secure a threshold?

Use adhesive to secure the threshold. Make sure the adhesive you choose is approved for use with both the threshold material and the floor material. Contact cement creates a strong, durable bond, but it won’t allow you reposition the threshold after you set it and apply pressure.

Can you glue down a threshold?

If the subfloor is concrete, you may need to glue the threshold down. To do this apply a strong adhesive to the edge of the wood flooring, and then place the threshold over the gap between the two sections of floor and push down on the piece to glue down.

You might be interested:  How To Frame A Concrete Patio?

What is the difference between a door sill and threshold?

DIY Frequently Asked Questions / What is the difference between the door sill and the threshold? The door sill is part of the frame structure of the door and sits under the door jamb. The threshold sits on top of the sill and performs the duty of making the door weathertight.

How do I fill the gap under my front door threshold?

Just shim the gap accordingly with door shims so the threshold rests on the shims. Then use door and window minimal expanding foam to fill it in and seal it.

Can I glue a transition strip?

You can attach the transition in one of two ways. You can glue it to the floor with liquid nails or you could use the track that comes with it to attach it. If you are using liquid nails, apply a bead of the liquid nails to the underside of the transition.

Leave a Reply

Your email address will not be published. Required fields are marked *