Often asked: How To Repair Expansion Joints In Concrete Driveway?

How do you repair concrete expansion joints?

How to Replace Concrete Expansion Joints

1. Sweep away any dirt and debris from the area.
2. Dig out and remove all the old material that’s in the joints with a putty knife.
3. With a wet-dry vacuum, clean out the joints between the slabs very well.
4. Apply a bonding adhesive, usually epoxy, into the joints with a brush.
5. Insert foam backer rod.
6. Cover and seal the joint.

What is the best concrete joint filler?

Akonaflex™ Expansion Joint Filler is a superior-grade, one-component, urethane sealant and filler to be used in concrete joints as well as a wide variety of substrates.

Can you use polymeric sand for expansion joints?

Pool PM says it doesn’t matter as long as there is a 3/8-½ inch expansion joint there. The deck builders say they often use polymeric sand between the pool beam and deck pavers. I heard that self-leveling sealant with a backer rod may be better from someone.

Should you fill concrete expansion joints?

Just remember that expansion joints should always be sealed and filled with a flexible joint sealer and never be epoxied or coated over. Contraction joints can be filled in the same manner after a coating or sealer is applied.

Should you caulk driveway expansion joints?

Caulking Concrete Cracks and Expansion Joints



Even expansion joints in your concrete driveway should be caulked. Notice how the caulking is slightly lower than the concrete slab around it. This protects the caulk from wear and tear of people walking and driving over it.

What do you fill driveway expansion joints with?

Foam backer rods act to fill in space between concrete joints so you don’t need to use a ton of self-leveling sealant. Here’s a BIG TIP: the diameter of the backer rod should be 1/8 inch larger than the width of your concrete expansion joint. This will ensure a water tight seal.

What material is used for expansion joints in concrete?

Minimize Concrete Cracking and Damage with Expansion Joints. ASPHALT EXPANSION JOINT is composed of a blend of asphalts, vegetable fibers, and mineral fillers formed under heat and pressure between two asphalt-saturated liners. It is waterproof, permanent, flexible, and self-sealing.

What should I put between wood and concrete?

In most cases, either pressure-treated lumber or naturally durable lumber (defined by the IRC as the heartwood of redwood, cedar, black locust, and black walnut) is acceptable. In some cases, separating wood from concrete with a water-impervious membrane or vapor retarder is all that’s required.

How do I fill the gap between my garage and driveway?

The best way to repair your expansion gap is to use purpose-designed foam backer rods and self-leveling caulk. Both materials are available in most home improvement stores. Cut your foam backer rods to the proper length for your expansion gap and press them into the gap.

How long does polymeric sand last?

How long will the sand/dust last before it needs to be replaced? For Alliance polymeric sand and Dust – If the proper installation procedure is followed in terms of paver installation according to the ICPI and the Polymeric Sand installation according to Alliance, then 10 years.

Can you use polymeric sand to fill driveway cracks?

Sweep the polymeric joint sand into the cracks between the pavers as you would with other materials. It is recommended that you do this three times to ensure that all of the joints are properly topped off. This will increase weed, insect and water protection.

Does water drain through polymeric sand?

Polymeric sand, if installed properly, will harden to lock you pavers in place and create a more effective weed and insect deterent while still allowing water to drain freely.