Often asked: How To Remove Concrete Driveway?

What is the easiest way to remove concrete?

Steps for Removing a Concrete Slab

1. Step 1: Create a Void Under the Concrete. The best way to speed up concrete removal is to create a void underneath the section of slab you’re working on.
2. Step 2: It’s Hammer Time.
3. Step 3: Pull Apart and Remove the Broken Concrete.
4. Step 4: Repeat Steps Until Concrete Is Demolished.

How much does it cost to get concrete removed?

The national average cost range is $500 – $5,000, with most homeowners paying around $1,856 to remove 600 square feet of concrete sidewalk.



Cost to Remove Concrete.

Concrete Removal Costs
National average cost	$1,856
Average range	$500 – $5,000
Minimum cost	$299
Maximum cost	$10,608

How do you break up thick concrete?

Start to break the concrete, starting six inches from the edge and working your way in. For slabs less than four inches thick, use a sledgehammer. For more than four inches thick, use a demolition hammer.

How do you break concrete by hand?

Instructions

1. Dig Under the Concrete. Dig out the soil, gravel, or other material from under the concrete, using a shovel and a pickax.
2. Strike the Concrete. Lightly sprinkle the concrete with water to minimize dust.
3. Pry Off Stubborn Pieces.
4. Move the Concrete Chunks With a Hand Truck.

Will a hammer drill break up concrete?

Hammer drills do not have a chiseling function and can be used to drill into a variety of materials. Rotary hammers use an electro-pneumatic hammer piston to generate high impact energy, which allows it to drill or demolish concrete.

How much will my concrete driveway cost?

Most concrete driveway installation costs between $1,800 and $6,000 or $4 to $15 per square foot. The average is just above $3,000 or $6 per square foot. Factors like location, size, decorative elements, potential reinforcement and removing the existing surface can all influence that range.

How much should a concrete driveway cost?

A concrete driveway costs from $8 to $18 per square foot, depending on decorative colors and finishes. While a plain gray concrete driveway costs between $5 and $7 per square foot to install. Concrete is ideal for getting the look of stone or pavers, without the high cost.

Can I lay grass on concrete?

Can I lay turf on a concrete or asphalt drive? Grass turf won’t live for long on a solid surface. Not even if you water it. It’s great for a temporary lawn – perhaps for a special event but if you want a forever lawn, you will need to break up the hard surface and replace it with some good quality topsoil.

Can I resurface my concrete driveway?

Concrete resurfacing to cover larger cracks or surface problems. Large cracks or holes greater than ¼”, spalling (horizontal peeling or chipping of the surface), and discoloration can be covered with resurfacing or a concrete overlay (a thin layer of cement-based material applied directly over the existing concrete).

Can you pour new concrete over old cracked concrete?

There are situations when pouring new concrete isn’t the most suitable option. For instance, surfaces with larger cracks, heaving or settling conditions, or where height cannot be raised, replacement is a better solution. However, in most cases, you can pour a new layer of concrete onto the existing one.

How do you make an old concrete driveway look good?

3 Ways to Make Old Concrete Look New Again

1. Power Wash. Over time, your concrete will accumulate grime and dirt.
2. Resurface. If you’re looking for a quick and easy way to improve your curb appeal, resurfacing your concrete steps and driveway is a great way to start.
3. Add Stain or Sealing Coats.
4. Revive Your Old Concrete.

Does anything dissolve concrete?

Concrete is a durable building material that takes special materials to dissolve once it’s hardened into place. Phosphoric acid and trisodium phosphate are the main compounds used to dissolve concrete leftover from masonry work. Sometimes, that doesn’t do the trick.

What is the best tool for breaking up concrete?

Tool #1: Sledgehammer + Pry Bar



When thinking about breaking up concrete, most of our minds jump straight to jackhammer. But you can probably do the work with a metal sledgehammer and a little elbow grease. Sledgehammer is the best tool to use if the slab of concrete is three inches thick or less.

What is the best concrete breaker?

My Top 7 Concrete Breakers

• DeWalt 110V 10KG Breaker.
• 2200W Electric Breaker Chisel Demolition Jack Hammer.
• Silverstorm 263570 – 1500W 15kg Electric Breaker 230V.
• PETROL: 1800W Gasoline Demolition Jackhammer Jack Hammer Concrete Drill Breaker Kit.
• PETROL: EBERTH 2.5 HP Petrol Demolition Hammer.