- 1 How thick does concrete need to be for a pond?
- 2 Is a concrete pond safe for fish?
- 3 How do you waterproof a concrete pond?
- 4 Can you make a pond out of concrete?
- 5 Does a concrete pond need to be sealed?
- 6 Is concrete toxic to fish?
- 7 What fish will clean my pond?
- 8 Is cement harmful to fish?
- 9 Will a concrete pond hold water?
- 10 What can I mix with cement to make it waterproof?
- 11 How do you waterproof a fish pond?
- 12 How much does it cost to build a fish pond?
- 13 Does concrete hold water?
How thick does concrete need to be for a pond?
you should be 9-10 inches with one or even two layers of mesh to be safe. I did not use a DPM as the stone is free draining but if you are below the water table it may save you problems when lining the pond.
Is a concrete pond safe for fish?
Concrete ponds can be “cured” and made safe for fish without any special coatings. Keep the newly constructed pond filled for a week, then drain and refill.
How do you waterproof a concrete pond?
A: The polyliner isn’t necessary to waterproof the concrete, but if you must, I would suggest using a product like Thoroseal, which can be found in most construction supply stores. It’s a cement-based product and does a good job of weatherproofing. You apply at least two coats to the concrete surface.
Can you make a pond out of concrete?
The basic construction of a concrete pond follows that of the liner ponds. The concrete should be 4 to 6 inches thick. Once the dimensions are established and an outline laid out, dig out the soil for the entire pond. Forms must be built in place to hold the concrete while it dries and cures.
Does a concrete pond need to be sealed?
You don’t need to re-seal your pond till years, once filled after application of Concrete fish pond sealant. You will have a great fish pond that will prove entertaining and easy to maintain for years.
Is concrete toxic to fish?
Concrete is harmless to fish once it has been leached. TO CURE – Newly cemented ponds release quantities of free lime into the water which is toxic to fish and plants. By curing the pond, this danger is removed. To cure, mix one-gallon household vinegar to each 200 gallons of water in your pond and let set three days.
What fish will clean my pond?
Fish that clean ponds by eating algae and other debris include the common pleco, the mosquitofish, the Siamese algae eater and the grass carp. Be careful with carp, koi and other bottom feeders. While they eat algae, they can also make your pond look dirty.
Is cement harmful to fish?
Often a freshly installed concrete waterfall is to blame, or a newly slabbed area adjacent to the pond. This is because the water that has run over the new cement and into the pond will have leached some lime from the cement. Lime will alter the PH value of the water making it deadly for the fish.
Will a concrete pond hold water?
Untreated concrete is usually quite porous, absorbing and allowing water to slowly seep through microscopic spaces, but it can be made highly resistant to the passage of water by using fine aggregates and waterproofing additives to close the pores.
What can I mix with cement to make it waterproof?
For the masonry of exterior walls with hard brick one often uses 1 part cement, 3.5 parts sand, 0.25 part lime. While for the same job, but with much softer limestone, a completely different mixing ratio is advised, namely 1 part cement, 9 parts sand, 2 parts lime.
How do you waterproof a fish pond?
Therefore, you need to seal the pond with a waterproofing compound like super laykold, a rubberised bitumen emulsion that can be reinforced with abe® membrane to provide a seamless professional waterproofing system. It is also non-toxic and koi/fish friendly.
How much does it cost to build a fish pond?
Some factors affecting price are size, depth and whether there are fish. The cost to build a pond is usually $2.50 to $7.15 per square foot. For a larger-scale project, like a lake, expect to pay $3,000 to $8,200 per acre or more. The overall price varies based on a variety of factors.
Does concrete hold water?
Does Concrete Absorb Water? Yes, concrete can absorb water because it’s porous like a sponge. When the ambient relative humidity is high, concrete can absorb water vapor (moisture) from the air. When the relative humidity is low, water will evaporate from the concrete into the ambient environment.