- 1 What is the minimum thickness for a concrete slab?
- 2 What kind of concrete do you use for a garage slab?
- 3 How deep should foundations be for a garage?
- 4 Can I pour a 2 inch concrete slab?
- 5 How many bags of concrete do I need for a 10×20 slab?
- 6 Can I pour concrete directly on dirt?
- 7 Does a garage slab need rebar?
- 8 Do you need footings for a garage slab?
- 9 Should you put a vapor barrier under concrete slabs?
- 10 What is the best foundation for a garage?
- 11 Can I build a garage on a concrete slab?
- 12 What size footings do I need for a garage?
- 13 Do you need rebar for 2 inch slab?
- 14 Do you need rebar for 4-inch slab?
- 15 Do you need gravel under concrete?
What is the minimum thickness for a concrete slab?
Standard concrete floor slab thickness is residential construction is 4 inches. Five to six inches is recommended if the concrete will receive occasional heavy load, such as mortar homes or garbage trucks. 120-150mm is minimum thickness.
What kind of concrete do you use for a garage slab?
The IRC requires that slabs be built with concrete with compressive strengths from 2500 to 3500 psi, depending on the climate. ACI goes further and recommends 4500-psi concrete for garages in the northern half of the country.
How deep should foundations be for a garage?
The depth of the foundations are a minimum of 750mm deep but the actual depth is determined on site depending on the soil conditions. The local Building Control officer will advise when he is satisfied with the depth. The width of the trench is dependent on the thickness of the walls.
Can I pour a 2 inch concrete slab?
If done properly, new concrete can often be poured right over an existing slab. For this to be feasible, the contractor needs to pour at least 2 inches thick, use smaller aggregate, and incorporate reinforcement such as welded wire mesh or fiber mixed into the concrete.
How many bags of concrete do I need for a 10×20 slab?
A 60-pound bag yields. 017 cubic yards, and an 80-pound bag yields. 022 cubic yards. For a 10 x 10 slab, you would need 77 60-pound bags or 60 80-pound bags.
Can I pour concrete directly on dirt?
Long story short, yes you can pour concrete over dirt.
Does a garage slab need rebar?
No, rebar is not required. Garage floors are poured last. Generally the thickness is usually about 4″ minimum plus. Many builders will not use rebar, nor do many provide control cuts.
Do you need footings for a garage slab?
All three types of slabs will need a footer and a slab of at least 4″ thick. The footer’s depth needs to be the frost line’s depth or as per local code, but no less than 12″ deep.
Should you put a vapor barrier under concrete slabs?
Water vapor will always move from a high relative humidity environment below the building into an area of low relative humidity – even through concrete. That’s why nearly every expert in the concrete industry recommends a below–slab vapor barrier to stop the vapor drive of water upward and into your building envelope.
What is the best foundation for a garage?
A concrete frost wall is the best foundation for any custom building. Prior to pouring the foundation, the site needs to be cleared and footing trenches are dug below grade in accordance to code. This type of foundation is built using a continuous footing that is set below frost level.
Can I build a garage on a concrete slab?
You may want to consider a 6″ thick slab for larger vehicles such as trucks or RVs. For a garage WITHOUT a floor – BUILT ON SITE: Prepare a level concrete slab at least 4” thick and to the exact, outside, dimensions of your garage. You may want to consider a 6″ thick slab for larger vehicles such as trucks or RVs.
What size footings do I need for a garage?
Dig trenches for your footings around the perimeter of your garage. Local building codes will specify the minimum depth and width of your trenches, but in general, the trenches should be at least 12” – 18” wide and minimum18” deep.
Do you need rebar for 2 inch slab?
Rebar should have a minimum 2″ embedment in the concrete. 2″ of concrete from the outside of the rebar to the surface. If your slab is going to be subjected to enough load to need rebar it will also need to be thicker; 6″ or 8″. depending on your engineer’s design.
Do you need rebar for 4-inch slab?
No, you do not need rebar for a 4–inch slab of concrete on grade. A 4–inch-thick slab cast on the ground and in permanent contact with it will float and rebar is not required. Rebar is recommended on concrete measuring 5 – 6 inches thick.
Do you need gravel under concrete?
Whether you pour concrete for a walkway or patio, a strong gravel base is required to prevent the concrete from cracking and shifting. Gravel is especially important in clay soil because it doesn’t drain well, which results in water pooling under the concrete slab and slowly eroding the soil as it finally drains.