Quick Answer: How To Figure Concrete Yard?

How much concrete do I need for a 10×10 slab?

For a 10 x 10 slab, we’d suggest a mix with a capacity of about 4,000 pounds per square inch, or psi. This is basic for residential projects, and it can withstand traffic and support heavy loads.

How many square feet will 3 yards of concrete cover?

One Cubic Yard of Concrete: 4-inches thick – covers 81 square feet. 5-inches thick – covers 65 square feet. 6-inches thick – covers 54 square feet.

How much is a cubic yard of concrete?

Use $90 per cubic yard as a ballpark figure for concrete prices, but concrete slab cost will vary by region. Also, expect a fee of about $60 per load for delivery from a concrete truck for concrete cost.

How many bags of concrete makes a yard?

On average, it will take 90 40lb bags, 60 60lb bags, or 45 80lb bags to fill one cubic yard of concrete.

You might be interested:  Often asked: How To Lay Carpet Over Concrete?

How many 80lb bags of concrete makes a yard?

If you’re using 80lb bags of concrete, you’ll need 45 bags to make a yard.

How many bags of cement do I need for 100 square feet?

4 bags ( 401 kg) of cement and 1593 nos bricks are required for 100 square feet 13.5 inch brick wall.

How much does it cost to pour a 12×12 concrete slab?

How much does a 12×12 concrete slab cost? The average cost to pour a 12×12 concrete slab that is 4” thick is between $888 and $1,584, with professional labor and materials included.

How many bags of quikrete make a yard?

One 80lbs bag of Quikrete Concrete Mix will yield approximately. 60 cu ft. So it will take 45 bag to equal one cubic yard of concrete. If you have a project over a 1/2 a cubic yard you should consider our Mix On-site Concrete especially if you are hand mixing.

Can I pour a 2 inch concrete slab?

If done properly, new concrete can often be poured right over an existing slab. For this to be feasible, the contractor needs to pour at least 2 inches thick, use smaller aggregate, and incorporate reinforcement such as welded wire mesh or fiber mixed into the concrete.

Is it cheaper to mix your own concrete?

One of the least expensive ways to get concrete is to mix your own. You can buy bags of the mix from a home improvement store. Typically, you only have to add water for it to be ready to pour. Otherwise, you risk getting a weaker concrete once it cures, which could lead to cracks or crumbles within a couple of years.

You might be interested:  Often asked: Tape That Sticks To Concrete?

How much is a truck load of concrete?

The average cost of concrete delivery is $119 to $147 per cubic yard for a full 10-yard truckload of ready-mix concrete, and $172 per yard for a short- load of less than 10 yards. The cost of concrete to pour a sidewalk is $255 to $320, while a driveway or garage slab runs $1,060 to $1,270.

How many bags of cement do I need for 1 cubic yard?

Pure cement, sand and crushed rock all have about the same density, so a block of pure cement measuring 1 cubic yard of volume (about 3,600 pounds) will contain 45 bags of cement.

How many 60 pound bags of concrete are in a yard?

60 pound bag yields. 017 cubic yards.

How many bags of concrete do I need for a post hole?

Mix two 50lb bags of concrete with water in a mixing tub or 5-gallon bucket. Add concrete into the hole and around the 4” x 4”. Depending on your climate, let concrete set up for 24 – 48 hours.

Leave a Reply

Your email address will not be published. Required fields are marked *