Question: How To Move A Tub Drain In A Concrete Floor?

How do you move a drain in a concrete floor?

How to Move a Shower Drain in a Concrete Floor

1. Step 1: Mark Cuts With Red Crayon.
2. Step 2: Take Safety Precautions.
3. Step 1: Cut With an Angle Grinder.
4. Step 2: Break Concrete Into Smaller Pieces.
5. Step 1: Dig Trench for New Pipe.
6. Step 2: Purchase Correct Size Drain Line.
7. Step 3: Cut Old Drain Line.
8. Step 4: Reattach Old Drain Line Piece.

Can you move plumbing on a concrete slab?

Moving the Water Lines The average cost for moving the plumbing in a 200 square foot kitchen with a slab floor is $2,000 to $7,000. And the cost for the pipes themselves ranges from $10 to $50 per linear foot. And this does not include any concrete work that it would take to get to the pipes.

Can a bathtub drain be moved?

A change in bathtub location requires new sewer pipe. These pipes attach the tub’s P-trap to a coupling that connects to the home’s sewer line. They are usually glued in, and if you need to move your drain, you will be working with these and white PVC or black ABS sewer pipes.

How much does it cost to move a bathtub drain?

move a drain pipe national average cost

cost to move a drain pipe
National Avg. Materials Cost per line	$123.27
National Avg. Cost (labor and materials) for 1 line	$705.25
National Cost Range (labor and materials) for 1 line	$632.63 – $777.87

Can a shower drain be connected to a toilet drain?

You cannot connect a shower to the toilet drain or what would be the waste arm. It needs to be piped within a properly vented branch, unless you revent the new shower line which I be leave you are under the IPC code would need to be wet vented.

Can I use a basement floor drain for a shower?

A basement drain is often a “French” or “princess” drain, designed for intermittent use. They aren’t designed for a constant, moderate flow of water, and will back up. If the drain is traditional and tied to existing sewer, yes it can be used as a shower drain.

How is plumbing run on a slab?

During the plumbing slab construction, the pipes are buried in gravel or sand beneath the slab and are (obviously) difficult to access. The plumbing through slab isn’t easy to reconfigure once placed. Modern homes are more likely to have a moisture barrier that protects a concrete slab.

Can you run water pipes in a concrete floor?

During the initial building of a home that has a concrete slab foundation and basement level, any plumbing that runs under the home must be put in before the concrete is poured, since the plumbing runs in the dirt, not within the actual concrete.

Can you rearrange a bathroom?

Homeowners can put as much or as little as they want into their bathroom remodel. It could be as simple as replacing the shower like for like with a new and improved model, or it could involve tearing the room out completely and giving it a complete makeover.

How do I move my bathtub drain from the center drain to the right drain?

Insert the straight piece of PVC into the open end of the elbow. Slip a new elbow on the opposite end of the straight pipe. Attach the new P-trap to the elbow. Check the measurement once more to ensure the open end of the P-trap is at the center mark of the new drain location.

Where should a shower drain be located?

The shower drain has to be at the lowest point of the shower floor, and so the floor has to slope down toward the drain from all directions. If the drain is in the center of the floor, you’ll have a relatively level space around the drain to stand on.

Is it expensive to move a shower?

A typical shower will cost an average of around $3,000. Adding extra showerheads, ceiling showerheads, and heated floors will significantly increase the price. If you’re relocating the shower, expect to pay an extra $900 – $1,200 (same as the toilet).