Question: How To Move A Shower Drain In A Concrete Floor Video?

Can you move plumbing on a concrete slab?

Moving the Water Lines The average cost for moving the plumbing in a 200 square foot kitchen with a slab floor is $2,000 to $7,000. And the cost for the pipes themselves ranges from $10 to $50 per linear foot. And this does not include any concrete work that it would take to get to the pipes.

How do you install a floor drain in a concrete slab?

How to Install a Floor Drain in a Concrete Slab

  1. Prepare Your Space. While it’s easiest to install a floor drain prior to pouring your cement, you can do it after the floor has been set.
  2. Plan Drainage. New floors are easier to plan, as you can lay out the pipes in place and then install the floor over top.
  3. Dig Trenches.
  4. Pour New Concrete.
  5. Add a Drain Cover.

Can I move a shower drain?

Sometimes moving a shower drain requires removing a concrete floor. Many bathroom remodeling jobs involve moving or replacing the shower stall. This often requires moving a drain connection that penetrates a concrete floor.

You might be interested:  FAQ: What Salt Is Safe For Concrete?

Does the shower drain have to be centered?

The shower drain has to be at the lowest point of the shower floor, and so the floor has to slope down toward the drain from all directions. For showers that have a bench built in, placing the drain under the bench will keep it out of the way.

How is plumbing run on a slab?

During the plumbing slab construction, the pipes are buried in gravel or sand beneath the slab and are (obviously) difficult to access. The plumbing through slab isn’t easy to reconfigure once placed. Modern homes are more likely to have a moisture barrier that protects a concrete slab.

Can you run water pipes in a concrete floor?

During the initial building of a home that has a concrete slab foundation and basement level, any plumbing that runs under the home must be put in before the concrete is poured, since the plumbing runs in the dirt, not within the actual concrete.

Can you install a toilet on a concrete floor?

You can install a toilet on a concrete floor. It may seem intimidating, but installing a new toilet can be a DIY project that you can be proud of.

Can I put a drain in my garage floor?

Can you put a floor drain in an existing garage? Yes, even if the floor is just a concrete slab. The drain can be attached to an existing sewer line or just flow to a runoff outside. If water is pooling in your garage, a floor drain can help you remove the mess before it spreads into your house.

You might be interested:  Installing Cabinets On Concrete Floor?

Does a garage floor drain need a trap?

Each fixture needs a trap. You could oversize the drain line so it acts as it’s own vent. dan is 100% right. around mass, they want the garage floor sloped to the door with no floor drain.

How do you Slope a concrete floor drain?

You need 1/4 inch of slope for every linear feet of floor space. For example, a floor that extends 4 feet away from the drain should have 1 inch of overall slope. Mark this outer height mark along the wall with a pencil. Mix up some concrete mix in the mixer.

Where does a linear shower drain go?

As a general rule-of-thumb, linear drains are located at either the back or side wall of where the fixtures are installed, or along the threshold or entrance.

How do you Slope a shower floor for a linear drain?

SLOPE /PITCH All wet ( shower ) areas must have a sloped floor towards the outlet at ¼” per foot (consult local codes for your area). Traditionally this is a 4-way slope towards the center of the wet area significantly limiting design options and tile size choice.

Leave a Reply

Your email address will not be published. Required fields are marked *